Product Description:
Green product
No electricity
No batteries
take anywhere
Great for Active lifestyles
Compact carry case included
1) Unlike gravity camp showers need to be hung overheat, Trend vane pressure shower sits on the ground and delivers the pressure you need to wash hair, do dishes, rinse off gear or wash the dog.
2) Use the foot pump to regulate the water pressure.
3) It has a 2.9 gal (11liter) capacity to provide 5~7 min of steady water pressure.
4) Includes a 7ft hose with spray nozzle.
5) Handle water temperature up to 50degrees.
6) Rigid design with heavy duty plastic welds.
7) Packs down to 5.5*8.5 inch in a ventilated zippered carrying case, weighs only 1lb 9oz.

Unpack your Pressure shower.
1. Unpack all components from the box
a. Contents should be one holding tank, one shower rose and hose, one pump and hose & one storage bag.
Setting up your shower.
1. Connect pump to holding tank,
a. Locate the small hose coming from the pump and connect this to the small barbed hose connection, there is two barbed hose connections located at the bottom of the holding tank, one small and one large, Connect the pump to the small barbed connection.
2. Connect shower hose and rose to holding Tank.
a. Locate the hose with shower rose attached and connect this to the large barbed hose connection, there is two barbed hose connections located at the bottom of the holding tank, one small one large, connect the hose with shower rose to the large barbed connection.
b. Refer to image on packaging for quick check and setup.
3. Using the pressure shower.
a. Fill water to desire level by opening the fill/Release cap at the top of the holding tank, you can fill to at least half way or ¾ full in the holding tank with water. If using hot water, please make sure that it is not boiling and does not exceed more than 50 degrees as this will damage the unit. Also this will ensure you do not burn yourself when showering. Using hot boiling water will void your warranty. If you plan to use the sun to heat your water do not exceed more than 3hrs in midday sun, and make sure the fill/release valve is not closed. Check Water temp is ok with back of hand first before using on anyone or animal.
b. Once fill level is reached, replace the cap at the top of the holding tank and make sure this is firmly pressed in to create a good seal.
c. Inflate holding tank by pressing down on the blue pump area with the greenshower logo on and inflate holding tank until firm, The pump is small pad with black base with the greenshower logo on top.
d. Squeeze trigger on shower rose to allow water to pass through to shower rose, this may take a few seconds as air is released in hose.
e. Use the shower at your convenience.
4. Packing the pressure shower up.
a. Allow the unit to completely dry inside the holding tank, a good way to dry it is to mount the tank upside down with the fill/pressure release valve open.
b. Reverse the above procedure.
c. Please do not pack away the unit wet for extending period of times as this will void your warranty.

Quick tips and Hints
- If the flow is slow or weak please press the pump a few more times to increase the pressure in the bag.
- Sometimes you may need to pump the pump while showering if the rose is positioned two high in the air. 1.5m is recommended.
- To assist with flow, raise the holding tank higher in the air. You can do this by placing on top of a table or stool.
- Keep the unit clean by using low abrasive detergents, do not scrub the holder tank or hose but simply wipe dry with a soft cloth. If you need to clean the internal Holding tank a standard house hold detergent and some luke warm water put in the holding tank and pumped thorough the shower rose will help clean the nozzle and hose.
- Dirty Dam/Creek water is not recommended for this unit and can damage the components, if you wish to use water from a dam or creek, please make sure it is free from heavy debris, sticks and dirt.
- For any further information please contact your store of purchase.