“ANCHOR POINT” Series – See Through Design

Innovative “Anchor Point” design provides superior mount stability
See through design for continued use of fixed iron sights
Installs in minutes, no permanent modification or rifle disassembly required
No straight bolt handle or stripper clip interference
No contact with stock
Recoil lug nut spanner wrench included
Unit comes loosely preassembled
Rigid all steel construction, include 5/16” x 8” MIL-STD 1911 Picatinny Rail
Made in America, 100% Lifetime Warranty
*This mount fits the majority of 8mm mil surp Mauser variant designs with K98 type recoil lug and rear sight blocks (K98k, M24/47, M48, etc.). It will fit the Model 1916 Spanish Mausers with recoil lug and the FN Herstal 7mm x 57 Venezuelan short. It will NOT fit Argentine, Chilean, Czechoslovakian, Swedish, Spanish or Turkish Mausers. PLEASE READ FITMENT NOTES BEFORE PURCHASING!

SPECIFICATIONS:

The mount will accommodate a front to back (horizontal) distance of 5.86" (148.9mm) to 6.26" (159.1mm) from the center of the recoil lug to the center of the rear sight block pivot. It also allows for an up and down (vertical) distance of 1.32” (33.6 mm) to 1.67” (42.3 mm) from the same. The rear sight riser block is designed to fit over rear sight blocks that measure a maximum of .74” (18.9 mm) wide. The total weight including hardware is 9.5 oz. However, the net weight increase is only 8.7 oz. due to the replacement of the original recoil lug bar and nut.

INCLUDED: Hex body spanner wrench for recoil lug nut IS included. All necessary hardware, hex wrenches and complete installation instructions.

MOUNT DOES NOT INCLUDE SCOPE & RINGS!

FITMENT NOTES:

We have made every reasonable effort to ensure that this product will fit the majority of *Mauser rifle variants. However, due to the large number of these firearms produced over many years around the world, it is impossible for us to allow for all manufacturing variation. As with any of our products, it may be returned undamaged for a full refund. The mount can only accommodate so much misalignment. You should measure the center distances as described in the specifications to ensure that the mount will fit properly. Proper tightening of all hardware should result in no movement of the mount during normal firing recoil.